Bizfon 680 Especificaciones descargar pdf (Pagina 35)

Bizfon Owner’s Guide

35

Appendix A

Startup/Test

Button

Using the Star-

tup/Test Button

After connecting your telephone lines and

telephones, you can use the Startup/Test but-

ton to confirm that your Bizfon 680 is prop-

erly set up.

1. Press the Startup/Test button (the blue

button in the center of the Bizfon 680)

once. A welcome message is played

along with a notification that the system

cannot be used for incoming or outgoing

calls while being tested. When you press

the button again, calls in progress will be

halted. You should wait until all LEDs

located at the telephone jacks are off,

indicating that no one is on the phone.

2. Press the button again to start the test for

the Incoming Telephone Lines. A mes-

sage tells you that the Incoming Lines

will be tested. The LEDs at each con-

nected line will flash as the diagnostics

detect a dial tone. The test will be

repeated every 7 seconds. If an LED at a

jack with a line connected does not flash,

it indicates that a dial tone is not

detected. Check to make sure that the

line is connected to a wall jack with a

live Incoming Telephone Line. Be sure to

wait at least 10 seconds after changing

any connections before pressing the but-

ton again to proceed to the next test.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 49 50

Comentarios a estos manuales

Sin comentarios